Bertram31.com General Bulletin Board

Re: Cutlass install

Posted By: Scott
Date: Wednesday, 7 June 2006, at 9:47 p.m.

In Response To: Re: Cutlass install (Capt Patrick McCrary)

I have to think Al means to replace an existing cutlass with a new one with the shaft in place. I had to turn down a piece of pipe to a diameter slightly smaller than the cutlass case to drive out the old one. On install it was as Capt. Patrick discribed, except the oak had a 1 1/2" hole cut into it.

Scott

Messages In This Thread

Cutlass install
Al -- Wednesday, 7 June 2006, at 8:38 p.m.

Re: Cutlass install
Capt Patrick McCrary -- Wednesday, 7 June 2006, at 8:57 p.m.

Re: Cutlass install
Scott -- Wednesday, 7 June 2006, at 9:47 p.m.

Re: Cutlass install
Al -- Wednesday, 7 June 2006, at 11:01 p.m.

Re: Cutlass install
bruce -- Thursday, 8 June 2006, at 7:27 a.m.

Re: Cutlass install
Tom Annulli -- Thursday, 8 June 2006, at 10:38 a.m.

Re: Cutlass install
Al -- Thursday, 8 June 2006, at 11:43 a.m.

Re: Cutlass install
Tommy -- Thursday, 8 June 2006, at 12:24 p.m.

Re: Cutlass install
Jerry Gomber -- Thursday, 8 June 2006, at 1:30 p.m.

Re: Cutlass install
JP -- Thursday, 8 June 2006, at 8:16 p.m.

Re: Cutlass install
Skipper Dick -- Thursday, 8 June 2006, at 3:00 p.m.

Re: Cutlass install
bruce -- Thursday, 8 June 2006, at 3:31 p.m.

Re: Cutlass install
RussP -- Thursday, 8 June 2006, at 4:27 p.m.

Re: Cutlass install
Al -- Thursday, 8 June 2006, at 6:17 p.m.