Bertram31.com General Bulletin Board

Re: thinning polyster resin

Posted By: Capt Patrick McCrary
Date: Sunday, 4 June 2006, at 3:25 p.m.

In Response To: thinning polyster resin (phil)

Phil,

If you're thinning for penetration into wood, you can use acetone. About 10% - 15% should do. After it tacks up into the cure, apply a second coat of un-thinned resin, allow again to tack & you're ready for your first course of fiberglass.

Br,

Patrick

Messages In This Thread

thinning polyster resin
phil -- Sunday, 4 June 2006, at 2:30 p.m.

Re: thinning polyster resin
Capt Patrick McCrary -- Sunday, 4 June 2006, at 3:25 p.m.