Bertram31.com General Bulletin Board

Re: Prop puller

Posted By: Vic Roy
Date: Thursday, 15 December 2005, at 8:35 p.m.

In Response To: Re: Prop puller (Scott)

Scott, that is a good observation, but the Tef Gel is a thin film product, in the ilk of Corrosion X, and not really a lubricnt like grease. If the prop is honed on the shaft taper anywhere near correctly, then the amount of shaft to prop bore contact is 10 times what a "slap on" job is. The Tef Gel will get so thin it's not an issue on friction, just prevents galling between the shaft taper and the prop. Tef Gel, like Corrosion X, is just a totally different approach to keeping metal mating parts from galling without "greasing" them.

UV

Messages In This Thread

Prop puller
Classic Trade -- Thursday, 15 December 2005, at 9:20 a.m.

Re: Prop puller *LINK*
Rawleigh -- Thursday, 15 December 2005, at 10:04 a.m.

Re: Prop puller
Capt. Dick Dean -- Thursday, 15 December 2005, at 10:53 a.m.

Re: Prop puller
Harv -- Thursday, 15 December 2005, at 11:52 a.m.

Re: Prop puller
Tony Meola -- Thursday, 15 December 2005, at 8:50 p.m.

Re: Prop puller
Mike Dolan -- Thursday, 15 December 2005, at 1:43 p.m.

Re: Prop puller
Scott -- Thursday, 15 December 2005, at 12:35 p.m.

Re: Prop puller
Ed C. -- Thursday, 15 December 2005, at 3:07 p.m.

Re: Prop puller
cwj -- Thursday, 15 December 2005, at 3:34 p.m.

Re: Prop puller
craig mac -- Thursday, 15 December 2005, at 4:08 p.m.

Re: Prop puller
Vic Roy -- Thursday, 15 December 2005, at 5:37 p.m.

Re: Prop puller
Scott -- Thursday, 15 December 2005, at 7:28 p.m.

Re: Prop puller
Vic Roy -- Thursday, 15 December 2005, at 8:35 p.m.

Re: Prop puller
Rawleigh -- Thursday, 15 December 2005, at 10:52 p.m.

Re: Prop puller
Classic Trade -- Friday, 16 December 2005, at 9:17 a.m.

Re: Prop puller
John F. -- Friday, 16 December 2005, at 10:27 a.m.

Re: Prop puller
Classic Trade -- Friday, 16 December 2005, at 11:53 a.m.

Re: Prop puller
John F. -- Friday, 16 December 2005, at 12:03 p.m.

Re: Prop puller
sean -- Monday, 19 December 2005, at 2:26 p.m.