Bertram31.com General Bulletin Board

Re: SHAFT COUPLING

Posted By: Vic Roy
Date: Thursday, 1 September 2005, at 7:47 a.m.

In Response To: SHAFT COUPLING (Chris Wilson)

Chris - the gear end is straight, just a keyway and the setscrews in the coupling hold it in place. Be sure to "dimple" the shaft through the set screw holes to give a good bite on the shaft so it won't back out of the coupling when in hard reverse.

UV

Messages In This Thread

SHAFT COUPLING
Chris Wilson -- Thursday, 1 September 2005, at 7:03 a.m.

Re: SHAFT COUPLING
Vic Roy -- Thursday, 1 September 2005, at 7:47 a.m.

Re: SHAFT COUPLING
Capt Patrick McCrary -- Thursday, 1 September 2005, at 7:50 a.m.

Re: SHAFT COUPLING
Capt. Dave Kosh -- Thursday, 1 September 2005, at 10:47 a.m.