Bertram31.com General Bulletin Board

Re: Thin wall cutlass bearings

Posted By: Capt. Dave Kosh
Date: Tuesday, 30 August 2005, at 9:42 a.m.

In Response To: Re: Thin wall cutlass bearings (Mike Kennedy)

Paul ,

As per Patrick I had Advanced Machine Repair in Ft. Myers do both of mine. They did an excellant job. This all assuming you do not have severe electrolysis on your present struts. Dave K

Messages In This Thread

Thin wall cutlass bearings
Paul Haggett -- Tuesday, 30 August 2005, at 6:21 a.m.

Re: Thin wall cutlass bearings
Carl -- Tuesday, 30 August 2005, at 7:32 a.m.

Re: Thin wall cutlass bearings
Capt Patrick McCrary -- Tuesday, 30 August 2005, at 7:32 a.m.

Re: Thin wall cutlass bearings
Mike Kennedy -- Tuesday, 30 August 2005, at 8:34 a.m.

Re: Thin wall cutlass bearings
Capt. Dave Kosh -- Tuesday, 30 August 2005, at 9:42 a.m.

Re: Thin wall cutlass bearings
Carl -- Tuesday, 30 August 2005, at 12:22 p.m.

Re: Thin wall cutlass bearings
Capt Patrick McCrary -- Tuesday, 30 August 2005, at 2:26 p.m.

Re: Thin wall cutlass bearings
Carl -- Tuesday, 30 August 2005, at 5:43 p.m.

Re: Thin wall cutlass bearings
Capt Patrick McCrary -- Tuesday, 30 August 2005, at 6:01 p.m.

Re: Thin wall cutlass bearings
Paul Haggett -- Wednesday, 31 August 2005, at 6:28 a.m.