Bertram31.com General Bulletin Board

Re: Thin wall cutlass bearings

Posted By: Capt Patrick McCrary
Date: Tuesday, 30 August 2005, at 7:32 a.m.

In Response To: Thin wall cutlass bearings (Paul Haggett)

Paul,

Did H&H give a reason specifically for your struts or is this just a policy decision?

If your struts are in good condition, e.g. no electrolisis metal loss, then they can be bored for the thin wall bearing. The bearing has a 2" O.D. & only 1/16" of wall surface has to be removed.

If you can't find a local source for the work, you could send them to me and I'll have Robert do the work. He's done at least 6 sets for me alone.

Br,

Patrick

Messages In This Thread

Thin wall cutlass bearings
Paul Haggett -- Tuesday, 30 August 2005, at 6:21 a.m.

Re: Thin wall cutlass bearings
Carl -- Tuesday, 30 August 2005, at 7:32 a.m.

Re: Thin wall cutlass bearings
Capt Patrick McCrary -- Tuesday, 30 August 2005, at 7:32 a.m.

Re: Thin wall cutlass bearings
Mike Kennedy -- Tuesday, 30 August 2005, at 8:34 a.m.

Re: Thin wall cutlass bearings
Capt. Dave Kosh -- Tuesday, 30 August 2005, at 9:42 a.m.

Re: Thin wall cutlass bearings
Carl -- Tuesday, 30 August 2005, at 12:22 p.m.

Re: Thin wall cutlass bearings
Capt Patrick McCrary -- Tuesday, 30 August 2005, at 2:26 p.m.

Re: Thin wall cutlass bearings
Carl -- Tuesday, 30 August 2005, at 5:43 p.m.

Re: Thin wall cutlass bearings
Capt Patrick McCrary -- Tuesday, 30 August 2005, at 6:01 p.m.

Re: Thin wall cutlass bearings
Paul Haggett -- Wednesday, 31 August 2005, at 6:28 a.m.