Bertram31.com General Bulletin Board

Re: Questions

Posted By: ken ching
Date: Tuesday, 16 August 2005, at 9:57 p.m.

In Response To: Questions (Butch Fryling)

Butch, the jig for a Cummins engine is not that hard to make. I made mine out of 1x4s. Just get all the dementions from the cummins people and whatever trans you are using and mount the engine isolators on the jig and you are ready to go. Ken

Messages In This Thread

Questions
Butch Fryling -- Tuesday, 16 August 2005, at 9:51 p.m.

Re: Questions
ken ching -- Tuesday, 16 August 2005, at 9:57 p.m.

Re: Questions
Pete Fallon -- Wednesday, 17 August 2005, at 5:27 a.m.

Re: Questions
capy -- Wednesday, 17 August 2005, at 11:21 a.m.

Re: Questions
Capt Patrick McCrary -- Wednesday, 17 August 2005, at 7:53 a.m.

Re: Questions
Pete Fallon -- Wednesday, 17 August 2005, at 11:53 a.m.

Re: Questions
Dug -- Wednesday, 17 August 2005, at 1:55 p.m.

Re: Questions
JIM -- Wednesday, 17 August 2005, at 2:03 p.m.

Re: Questions
Pete Fallon -- Wednesday, 17 August 2005, at 3:33 p.m.

Re: Questions
thudddd -- Wednesday, 17 August 2005, at 4:13 p.m.

Re: Questions
RussP -- Wednesday, 17 August 2005, at 10:51 p.m.

Re: Questions
Pete Fallon -- Thursday, 18 August 2005, at 3:04 p.m.