Bertram31.com General Bulletin Board

Re: Stripping the bottom

Posted By: Harv
Date: Thursday, 12 May 2005, at 10:02 p.m.

In Response To: Re: Stripping the bottom (Paul Haggett)

Paul,

Are you referring to the Interlux Pint-Off? I used that goop on my 26 center console, and then a year later on my B31. The 26 being smaller was actually fast and easy to do, however after doing the 31 the following season, swore never to do it again. Time consuming and repetative over the same areas before you get the results you want. Straight sanding would have taken me less time. If you want to do it yourself, just sand it and be careful. If you'd rather not do it than blasting by a pro is the only way to go.

Harv

Messages In This Thread

Stripping the bottom
Paul Haggett -- Thursday, 12 May 2005, at 6:46 a.m.

Re: Stripping the bottom
david jonesPaul -- Thursday, 12 May 2005, at 7:46 a.m.

Re: Stripping the bottom
phil -- Thursday, 12 May 2005, at 7:56 a.m.

Re: Stripping the bottom
John F. -- Thursday, 12 May 2005, at 7:57 a.m.

Re: Stripping the bottom
Ian Upton -- Thursday, 12 May 2005, at 8:17 a.m.

Re: Stripping the bottom
Bill -- Thursday, 12 May 2005, at 2:39 p.m.

Re: Stripping the bottom
Paul Haggett -- Thursday, 12 May 2005, at 4:36 p.m.

Get it blasted!
BillC -- Thursday, 12 May 2005, at 6:32 p.m.

Re: Stripping the bottom
Harv -- Thursday, 12 May 2005, at 10:02 p.m.

Re: Stripping the bottom
Paul Haggett -- Friday, 13 May 2005, at 6:43 a.m.