Bertram31.com General Bulletin Board

Re: Floscan question for Bruce

Posted By: bruce
Date: Thursday, 5 May 2005, at 4:07 p.m.

In Response To: Re: Floscan question for Bruce (Rawleigh)

They can be off out of the box due to display working with different types of sensors. Its not a problem.
Best way is to get the 9000 head calibrated and once checked the lower station can be dialed in.

The calibration procedure is in the paperwork.

Two sensor gas, same engine one 18-4rf cable.

Two sensor gas, two engines two 18-3rf cables.

Each sensor has a +12, ground and white sensor wire.

If you have the display tied to the ignition, you can feed back thru to the other ignition when it is off. You can always put in a diode, but two seperate cables is better.

Messages In This Thread

Floscan question for Bruce
Chiles -- Wednesday, 4 May 2005, at 9:17 a.m.

Re: Floscan question for Bruce
Rawleigh -- Wednesday, 4 May 2005, at 1:41 p.m.

Re: Floscan question for Bruce
Chiles -- Wednesday, 4 May 2005, at 2:42 p.m.

Re: Floscan question for Bruce
Rawleigh -- Wednesday, 4 May 2005, at 3:20 p.m.

Re: Floscan question for Bruce
Scott Deskins -- Wednesday, 4 May 2005, at 3:41 p.m.

Re: Floscan question for Bruce
Rawleigh -- Wednesday, 4 May 2005, at 3:47 p.m.

Re: Floscan question for Bruce
bruce -- Wednesday, 4 May 2005, at 7:09 p.m.

Re: Floscan question for Bruce
Chiles -- Thursday, 5 May 2005, at 8:32 a.m.

Re: Floscan question for Bruce
Scott Deskins -- Thursday, 5 May 2005, at 8:38 a.m.

Re: Floscan question for Bruce
Rawleigh -- Thursday, 5 May 2005, at 12:26 p.m.

Re: Floscan question for Bruce
bruce -- Thursday, 5 May 2005, at 4:07 p.m.