Bertram31.com General Bulletin Board

Re: Rub rail installation question!!!

Posted By: Paul Haggett
Date: Tuesday, 19 April 2005, at 8:52 p.m.

In Response To: Re: Rub rail installation question!!! (cwj)

Dug, I started my rub rail replacement last fall but temps got too cold to continue. I did learn that cutting a small piece off and running around the joint with that will tell you where you need to grind. You'll need three of you to get the bow piece on. Be careful to try and get the very tip to touch the hull and deck before fastening. We didn't pay close enough attention to it and I'm going to have to fill in the bottom when we're done.

I'd go with the hollow too.

Messages In This Thread

Rub rail installation question!!!
Dug -- Tuesday, 19 April 2005, at 8:57 a.m.

Re: Rub rail installation question!!!
Carl -- Tuesday, 19 April 2005, at 9:33 a.m.

Re: Rub rail installation question!!!
Dug -- Tuesday, 19 April 2005, at 10:25 a.m.

Re: Rub rail installation question!!!
russp -- Tuesday, 19 April 2005, at 6:37 p.m.

Re: Rub rail installation question!!!
cwj -- Tuesday, 19 April 2005, at 7:53 p.m.

Re: Rub rail installation question!!!
Paul Haggett -- Tuesday, 19 April 2005, at 8:52 p.m.

Re: Rub rail installation question!!!
bob lico -- Tuesday, 19 April 2005, at 10:00 p.m.

Re: Rub rail installation question!!!
Dug -- Wednesday, 20 April 2005, at 10:12 a.m.

Re: Rub rail installation question!!!
brucedoan -- Wednesday, 20 April 2005, at 11:17 a.m.

Re: Rub rail installation question!!!
Mitch -- Wednesday, 20 April 2005, at 9:09 p.m.

Re: Rub rail installation question!!!
Dug -- Thursday, 21 April 2005, at 9:51 a.m.

Re: Rub rail installation question!!!
brucedoan -- Thursday, 21 April 2005, at 10:19 a.m.

Re: Rub rail installation question!!! *LINK* *PIC*
Capt Patrick McCrary -- Thursday, 21 April 2005, at 9:37 a.m.

Re: Rub rail installation question!!!
brucedoan -- Thursday, 21 April 2005, at 1:19 p.m.

Re: Rub rail installation question!!!
Capt Patrick McCrary -- Thursday, 21 April 2005, at 1:36 p.m.