Bertram31.com General Bulletin Board

Re: Epoxy / solvents / Awlgrip / Temperature

Posted By: Capt Patrick McCrary
Date: Wednesday, 23 March 2005, at 12:38 p.m.

In Response To: Re: Epoxy / solvents / Awlgrip / Temperature (Ian Upton)

Ian,

Any urethanes have to be protected from freezing, (Awlgrip, Imron, Briteside, etc), epoxies are OK even if they freeze and then thaw, (West System, epoxy Barrier Caots, Polypoxy, etc). None of them should be applied below 60°F.

Good luck in the frozen tundra...

Best regards,

Patrick

Messages In This Thread

Epoxy / solvents / Awlgrip / Temperature
Ian Upton -- Tuesday, 22 March 2005, at 8:53 p.m.

Re: Epoxy / solvents / Awlgrip / Temperature
Vic Roy -- Tuesday, 22 March 2005, at 9:29 p.m.

Re: Epoxy / solvents / Awlgrip / Temperature
russp -- Wednesday, 23 March 2005, at 5:35 a.m.

Re: Epoxy / solvents / Awlgrip / Temperature
Ian Upton -- Wednesday, 23 March 2005, at 10:37 a.m.

Re: Epoxy / solvents / Awlgrip / Temperature
Jerry Gomber -- Wednesday, 23 March 2005, at 10:49 a.m.

Re: Epoxy / solvents / Awlgrip / Temperature
Capt Patrick McCrary -- Wednesday, 23 March 2005, at 12:38 p.m.

Re: Epoxy / solvents / Awlgrip / Temperature
Ian Upton -- Wednesday, 23 March 2005, at 2:35 p.m.

Re: Epoxy / solvents / Awlgrip / Temperature
John S -- Wednesday, 23 March 2005, at 11:25 p.m.