Bertram31.com General Bulletin Board

Re: shaft wear

Posted By: Joef
Date: Monday, 21 February 2005, at 2:31 p.m.

In Response To: Re: shaft wear (Carl)

John:

In addition to replacing the shaft, you need to figure out why it wore...otherwise you could be putting a new shaft in every few years. Tolerances measured in thousandths are impossible to see by naked eye...even a small bend in the shaft will cause unever wear...so will engine misalignment, bent struts etc. I had 1 3/8 AM22 shaft come out of my old 29 topaz and the wear under the cutlass was probably 1/8 inch all around!...i was lucky it didn't break...found out later that it was out of straight by 14/1000ths...not sure how they measured that...some sort of dial indicator with the shaft on V-blocks i think...still, you need to get everything back in line when you replace the shaft or you'll just keep having the problem

Joe
ps...500 or so sound reasonable to me..

Messages In This Thread

shaft wear
John Davis -- Sunday, 20 February 2005, at 10:09 p.m.

Re: shaft wear
Mitch -- Monday, 21 February 2005, at 6:46 a.m.

Re: shaft wear
Charlie Haws -- Monday, 21 February 2005, at 8:43 a.m.

Re: shaft wear
david jones -- Monday, 21 February 2005, at 9:00 a.m.

Re: shaft wear
Charlie Haws -- Monday, 21 February 2005, at 9:43 a.m.

Re: shaft wear
Capt. Dave Kosh -- Monday, 21 February 2005, at 9:55 a.m.

Re: shaft wear
Carl -- Monday, 21 February 2005, at 10:20 a.m.

Re: shaft wear
Joef -- Monday, 21 February 2005, at 2:31 p.m.

Re: shaft wear
John Davis -- Monday, 21 February 2005, at 3:16 p.m.

Re: shaft wear
cwj -- Monday, 21 February 2005, at 4:20 p.m.

Re: shaft wear
bruce doan -- Thursday, 24 February 2005, at 10:10 a.m.

Re: shaft wear
John Davis -- Monday, 21 February 2005, at 3:40 p.m.

Re: shaft wear
Capt. Dave Kosh -- Monday, 21 February 2005, at 4:53 p.m.

Re: shaft wear
Vic Roy -- Monday, 21 February 2005, at 6:05 p.m.

Re: shaft wear
Terry -- Monday, 21 February 2005, at 8:27 p.m.

Re: shaft wear
Vic Roy -- Monday, 21 February 2005, at 9:03 p.m.

Re: shaft wear - an alternative solution
Rawleigh -- Tuesday, 22 February 2005, at 11:06 a.m.

Re: shaft wear -
SIM -- Tuesday, 22 February 2005, at 12:08 p.m.

Re: shaft wear -
Capt. Dave Kosh -- Tuesday, 22 February 2005, at 12:27 p.m.

Re: shaft wear -
John Davis -- Tuesday, 22 February 2005, at 4:47 p.m.

Re: shaft wear -
Joef -- Tuesday, 22 February 2005, at 5:20 p.m.

Re: shaft wear -
Rawleigh -- Tuesday, 22 February 2005, at 5:21 p.m.

Re: shaft wear -
SIM -- Tuesday, 22 February 2005, at 5:58 p.m.

Re: shaft wear -
John -- Wednesday, 23 February 2005, at 1:43 p.m.