Bertram31.com General Bulletin Board

Re: Sealing Plywood with Epoxy

Posted By: Capt. Dave Kosh
Date: Monday, 17 January 2005, at 3:59 p.m.

In Response To: Sealing Plywood with Epoxy (John F.)

John,

As per Patrick's method and certainly the most widely accepted one that I heard as follows: 1 coat of thinned epoxy (25% Denatured Alcohol 75% Epoxy) put on first for deep penetration. Then 2 coats of full strength epoxy. Pay particular attention to the edges. The FB Cloth would be used where additional strength is required such as stringers or load bearing supports. Dave K

Messages In This Thread

Sealing Plywood with Epoxy
John F. -- Monday, 17 January 2005, at 1:35 p.m.

Re: Sealing Plywood with Epoxy
Capt. Dave Kosh -- Monday, 17 January 2005, at 3:59 p.m.

Re: Sealing Plywood with Epoxy
Rawleigh -- Monday, 17 January 2005, at 4:46 p.m.

Sealing existing backer plates with epoxy
Sean Burlingham -- Monday, 17 January 2005, at 8:57 p.m.

Re: Sealing existing backer plates with epoxy
Capt Patrick McCrary -- Tuesday, 18 January 2005, at 7:25 a.m.

Re: Sealing existing backer plates with epoxy
captdana -- Tuesday, 18 January 2005, at 8:55 a.m.

Re: Sealing existing backer plates with epoxy
Capt Patrick McCrary -- Tuesday, 18 January 2005, at 2:32 p.m.

Re: Sealing existing backer plates with epoxy
Scott Traenkle -- Tuesday, 18 January 2005, at 4:48 p.m.

Re: Sealing existing backer plates with epoxy
Sean Burlingham -- Thursday, 20 January 2005, at 11:24 p.m.