Bertram31.com General Bulletin Board

Re: Shaft/Vibration Question

Posted By: bruce doan
Date: Thursday, 23 December 2004, at 8:54 a.m.

In Response To: Shaft/Vibration Question (Capt. Dave Kosh)

I'm sure you'll locate the problem. One thing that has helped me and is easy to do after a new wheel install. I fasten a dial gage to the rudder and rotate the wheel. It doesn't tell me everything but, it determines correct prop-shaft alignment and if a blade has different angle[bent/twisted], depending on where the gage is located.

Messages In This Thread

Shaft/Vibration Question
Capt. Dave Kosh -- Wednesday, 22 December 2004, at 10:58 a.m.

Re: Shaft/Vibration Question
Joef -- Wednesday, 22 December 2004, at 1:49 p.m.

Re: Shaft/Vibration Question
Capt. Dick Dean -- Wednesday, 22 December 2004, at 3:27 p.m.

Re: Shaft/Vibration Question
Capt. Dave Kosh -- Wednesday, 22 December 2004, at 5:10 p.m.

Re: Shaft/Vibration Question
Capt Patrick McCrary -- Wednesday, 22 December 2004, at 5:21 p.m.

Re: Shaft/Vibration Question
Vic Roy -- Wednesday, 22 December 2004, at 5:36 p.m.

Re: Shaft/Vibration Question
Capt. Dave Kosh -- Wednesday, 22 December 2004, at 5:48 p.m.

Re: Shaft/Vibration Question
Capt. Dave Kosh -- Wednesday, 22 December 2004, at 5:45 p.m.

Re: Shaft/Vibration Question
bruce -- Wednesday, 22 December 2004, at 6:31 p.m.

Re: Shaft/Vibration Question
Capt. Dave Kosh -- Wednesday, 22 December 2004, at 7:33 p.m.

Re: Shaft/Vibration Question
bruce doan -- Thursday, 23 December 2004, at 8:54 a.m.

Re: Shaft/Vibration Question
Capt. Dave Kosh -- Thursday, 23 December 2004, at 10:01 a.m.