Bertram31.com General Bulletin Board

Bow rail question

Posted By: Chiles
Date: Tuesday, 9 November 2004, at 10:15 a.m.

I replaced the little 2x3 aluminum plates that rotted away under my front bow rail supports. I also sealed the top sides up real well while I was at it. I'm guessing the B28's are made the same way. Here is my issue;

When I tightened up the STB side, water started dripping out. It also tightened down (collapesd) more then I think it should. It's real hard to get to them from inside the bow locker, and that's the only way I can. The other rail supports appear to have no way to get to them at all unless I remove the carpet and cut holes behind what ever is lining the top of the V-Berth.

What would you guys do?

Chiles

Messages In This Thread

Bow rail question
Chiles -- Tuesday, 9 November 2004, at 10:15 a.m.

Re: Bow rail question
Capt. Dave Kosh -- Tuesday, 9 November 2004, at 10:27 a.m.

Re: Bow rail question
Chiles -- Tuesday, 9 November 2004, at 3:13 p.m.

Re: Bow rail question
toy104@aol.com -- Tuesday, 9 November 2004, at 5:04 p.m.

Re: Bow rail question
Rawleigh -- Tuesday, 9 November 2004, at 5:59 p.m.