Bertram31.com General Bulletin Board

Re: Engine room redo

Posted By: bruce doan
Date: Thursday, 4 November 2004, at 2:40 p.m.

In Response To: Engine room redo (Bob S)

Another approach I took was to use a [2] part "epoxy" paint used frequently at a commercial, [commercial fishing vessels],yard near by. [Tonys Marine Railway]. It's brushed on and used on wood, glass, and steel on hulls, decks, everywhere. The product name is "Devoe". It wears like iron and because it's brushed on it can be applied much thicker than spray, and has a minor ability in itself to smooth certain surfaces allowing limited access areas to be kept clean. It's also fast to apply.

Messages In This Thread

Engine room redo
Bob S -- Thursday, 4 November 2004, at 11:10 a.m.

Re: Engine room redo
Gary Gibson -- Thursday, 4 November 2004, at 1:26 p.m.

Re: Engine room redo
bruce doan -- Thursday, 4 November 2004, at 2:40 p.m.

Re: Engine room redo *LINK* *PIC*
Capt Patrick McCrary -- Thursday, 4 November 2004, at 5:48 p.m.

Re: Engine room redo
Mike Kennedy -- Thursday, 4 November 2004, at 6:42 p.m.

Re: Engine room redo
Capt Patrick McCrary -- Thursday, 4 November 2004, at 6:54 p.m.

Re: Engine room redo
Mike Kennedy -- Thursday, 4 November 2004, at 7:27 p.m.

Re: Engine room redo
Capt Patrick McCrary -- Thursday, 4 November 2004, at 7:40 p.m.

Re: Engine room redo
Mike Kennedy -- Thursday, 4 November 2004, at 7:47 p.m.

Re: Engine room redo
Capt Patrick McCrary -- Thursday, 4 November 2004, at 8:33 p.m.

Re: Engine room redo
Capt. Dave Kosh -- Friday, 5 November 2004, at 11:04 a.m.

Simplier yet
Capt. Mike Holmes -- Sunday, 7 November 2004, at 8:42 a.m.